 |
|
|
|
|
|
|
|
|
|
peter
90cc 2 stroke / 110 4 stroke
Joined: 05 Apr 2008
Posts: 62
Location: newcastle
|
 Posted: Tue Jun 22, 2010 1:19 pm Post subject: Atc250r 1986 rh crank collar o-ring |
  |
|
Does anyone know the dimensions for the o-ring that goes under the colar on your right side crank seal. Honda doesnt think it exists and its not on the parts fiche on this site . It may come with the collar when you buy it but for $40 its a bit of a risk when if it doesnt come with it you still have to purchase. Or has anyone got an engine apart with a good o-ring they could possibly meaure? Mine was cactus so i couldnt measure it.
If ive explained it bad its under clutch section on parts fiche for an 86 250r and it sits under part #3 (collar)
Cheers
_________________
lover of speed |
|
| |
|
|
|
|
|
|
|
|
Sponsor
|
|
|
|
|
|
|
|
|
Mart 300r
Roostin Away
Joined: 02 Jun 2008
Posts: 944
|
| Posted: Tue Jun 22, 2010 5:42 pm Post subject: |
|
|
I near bet the 84 r one is the same as well mate.
_________________
1984 ATC 300R, 1986 TRX 500R,1984 ATC 200X, ATC 70 WITH CUSTOM LAYDOWN 250R ENGINE, 125CC CUSTOM THUMPSTER TRIKE |
|
| |
|
|
|
|
|
|
|
|
peter
90cc 2 stroke / 110 4 stroke
Joined: 05 Apr 2008
Posts: 62
Location: newcastle
|
| Posted: Wed Jun 23, 2010 12:42 pm Post subject: |
|
|
Ok mart thanks but the 84 doesnt have a part # either so thats not really solving my problem unless you have one stripped down you could measure?? cheers
_________________
lover of speed |
|
| |
|
|
|
|
|
|
|
|
Jamie
Moderator
Joined: 27 Aug 2006
Posts: 749
Location: somewhere
|
| Posted: Wed Jun 23, 2010 1:11 pm Post subject: |
|
|
| rough measurements-27x22x3mm..thats for a 83/84 250r |
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
